JYTOP XLPE POWER CABLE

phone
You are here: Home » News » 1.5mm 2 core cable – KVV22 copper conductor steel tape armoured control cable

1.5mm 2 core cable – KVV22 copper conductor steel tape armoured control cable

Posted by: JYTOP Cable      Email:[email protected]

Leave a Reply

Your email address will not be published. Required fields are marked *

  • Power Cable

    Power Cable

    Power cables are mainly used for power transmission and distribution purpose. It is an assembly of one or more individually insulated electrical conductors, usually held together with an overall sheath. The assembly is used for transmission and distribution of electrical power. Electrical power cables may be installed as permanent wiring within buildings, buried in the ground and run overhead or exposed.……Including: rubber cable, welding cable, URD cable, XLPE insulated power calbe etc.

  • Bare Overhead Conductor

    Bare Overhead Conductor

    Bare Overhead Conductors are used in overhead transmission and distribution network applications.They are also used for un-insulated hook ups, jumpers, grounding conductors and other applications. Our Conductors conform to ASTM, IEC, BS, BS EN and DIN standards.…… Including: AAC conductor, AAAC conductor, ACSR conductor, ACAR conductor, AACSR conductor, etc.

  • Aerial Bundled Cable

    Aerial Bundled Cable

    Aerial bundled cables (also aerial bundled conductors or simply ABC) are overhead power lines using several insulated phase conductors bundled tightly together, usually with a bare neutral conductor. Our abc calbe conform to ASTM, IEC, SANS standards.……Including: abc cables, cvered line wire, service drop wire etc.

    • Two core or three conductor 1.5 square mm cable is generally without steel tape armoured, usually copper wire, thin steel wire or thin stainless steel wire braid armoured cable, require different, prices are different.
     
    Scope application of KVV22 cable:
     
    PVC insulated PVC sheathed control cables is suitable for rated voltage 450/750V and below or 0.6/1kV and below control, signal, protection and measurement system wiring.
     
    Control cable features:
     
    The rated power frequency voltage Uo/U is 450/750V or 0.6/1KV.
     
    The conductor – the maximum permissible operating temperature is 70℃.
     
    The cable laying temperature shall be not less than 0℃, if the ambient temperature is below 0℃, cable preheating.
     
    The cable permissible bending radius are as follows:
     
    Non armoured cable, not less than 6 times of cable diameter;
     
    Armoured or copper tape shielded cable, not less than 12 times of cable diameter;
     
    Shielded flexible cable, not less than 6 times the outer diameter of the cable.
     
    Control cable production range:
     
    Model Rated voltage (V) Nominal cross section (mm2)
    0.75 1.0 1.5 2.5 4 6 10
    Core number
    KVV KVVP 450/750V 2-61 2-14 2-10
    KVVP2 4-61 4-14 4-10
    KVV22 7-61 4-61 4-14 4-10
    KVVR 4-61 — —
    KVVRP 4-61 4-48 — —
    KVVP2-22 2-61 4-14 4-10
    KYJV KYJVP 2-61 2-14 2-10
    KYJV22 7-61 4-61 4-14 4-10
    KYJVP2 4-61 4-14 4-10
    KYJVR 4-61 — —
    KYJVRP 4-61 4-48 — —

    Pre:
    Next: BS5467 6943X 10mm 3 core swa cable